Custom design and manufacture of state-of-the-art
battery chargers, UPS, and power supplies for OEMs in a hurry?
This is a microprocessor controlled DC/DC converter with serial
communications and programmable with great flexibility.
Serial communications allows
you to control voltage, current, or power remotely, or to select on-board programs.
Very flexible input and output voltages available
Can be used for DC/DC converter, DC input battery charging, solar charge
controller, see specifications below.
Can use a voltage sense wire to maintain a constant voltage at the end of a long
run, for example on POE.
Output voltage can be higher or lower than the input voltage.
State-of-the-art charging algorithms available for a variety of battery chemistries
Use it as a constant voltage, constant power or
constant current supply
Input and output voltage and current sense can be
read by the on-boad microcontroller. Other A/D and digital input pins are available to adapt to
your needs, for example battery charge termination measurement, capacity testing, battery
quality testing, electrolysis, sensor control, etc.
Form factor and custom features can be designed to OEM
This product is a platform that can be programmed to meet your system
requirements. Typical programming fees are $500 to $2000 depending on complexity and test
Following is a custom modification of this technology for an OEM
||8-48 volts nominal, higher range possible
||2 volts to 80 volts available
||30 watts, 50 watts or higher depending on design
||-deltaV, (could be made to do delta T/ delta t, peak detect,
||Circuit board product, frame or case developed on request
||4" x 1.8" x 0.5" (10 cm x 4.6 cm x 2 cm) or smaller, depending
on power requirements
The basic 30 watt board is priced as follows